Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
How to Perform a Study
NXT Go Owner’s Manual, LBL-00145, MAN2030 41
Select the Stress Profile (On) toggle button to start the stress profile. The UPP
Puller will begin pulling at the speed selected in the Workflow Configuration
window.
Select the Stress Profile (Off) toggle button to mark the end of the profile. Click
the Puller Return button to return the UPP Puller NXT to the start position.
Manually reinsert the catheter and position just proximal to the bladder neck to
repeat the profile. Once the required number of profiles is complete, finish the
selected study.
3.6 Finishing the Studies
When all tests have been completed, remove any catheters and EMG patches from
the patient and dispose of them in accordance with hospital/clinic procedures.
Ensure to deflate Abdominal Fluid NXT Catheter Balloons before removal.
Empty the beaker. The beaker should then be thoroughly washed and reused.
Refer to the Maintenance and Service section on page 75 for further information.
Remove and dispose of the Infusion Pump Tubing and any other consumables
used during the study.
3.7 Printing the Study Result (Optional)
1. Select the patient from the Patients section, on the main screen, and click the
Studies tab in the Patient Details section.
2. Click the Report button. The report window will then be displayed using default
configuration as shown in the figure below.
3. Ensure that the printer is turned on and connected to the system. Click the Print
icon to display the Print pop-up window and click the OK button to print the
report.
NOTE: The user may also print the report at the end of the study once all data has
been recorded. A preview of the report is generated, the user can apply changes to the
report and then click the Print icon.
3.8 Troubleshooting
For FAQs and troubleshooting tips, refer to the Troubleshooting Guide section on
page 91. If problems cannot be resolved, contact the LABORIE Service team at 1-
800-333-1039 or email service@laborie.com.
Status DRAFT Effective