Owner's Manual

How to Perform a Study
NXT Go Owner’s Manual, LBL-00145, MAN2030 31
c) To connect the Remote Control NXT, ensure the remote control is active then click
the Search for devices button. This will cause the Find Devices window to pop-
up (Figure 18). Select the Remote Control NXT and click the OK button.
Figure 18: Find Devices Window
Choose the patient from the Patients section.
a) If the patient already exists in the system, select the patient and proceed to the
next step.
b) To add a new patient, click the New Patient button in the Patients section.
Enter the patient information in the Patient Details section under the Info tab
(Figure 35) and click the Save button to save the new patient details. If required,
input any relevant past medical history under the History tab. Once the patient
has been added, select the patient and proceed to the next step.
NOTE: The following fields are mandatory for completing new patient setup: First,
Last, and Birth Date.
To begin the study, ensure a patient is selected in the Patients section. Within
the Patient Details section, select any applicable symptoms under the
Symptoms tab immediately prior to starting the study. Symptoms are not
automatically saved in the patient details section. Symptoms are saved in the
study report. Next, select the applicable study under the UDS tab and click the
Start Study button.
IMPORTANT: Patient and test option must be selected to access the Start Study
Button. If the Start Study Button remains inaccessible after this step, verify that all
devices required for the study type are connected in the Device Manager and that all
hardware channels are set.
For more information on troubleshooting study start and workflow configuration, refer to the
Study Management section on page 55.
Status DRAFT Effective