Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Quick Start
NXT Go Owner’s Manual, LBL-00145, MAN2030 23
IMPORTANT: Removal of the Catheter Clamp may expose a sharp piece of metal
protruding from the hinge. Take care when handling.
To mount the UPP Puller NXT, slide the Pole Clamp onto the post of the UPP Stand. Ensure
that the yellow bushing is facing upwards. Lock it in position with the Rubber Knob Screw
located on the Pole Clamp. Loosen the thumb screw on the Pole Clamp and place the UPP
Puller NXT Arm Clamp Insert into the clamp’s yellow bushing (Figure 6).
Figure 6:Connect UPP Puller NXT Arm Clamp and the Pole Clamp
Tighten the thumbscrew to complete mounting. To adjust any of the joints on the UPP
Puller Arm, loosen the thumbscrews, adjust, and retighten. Refer to Figure 7.
IMPORTANT: Loosen the thumbscrews only as much as is required to complete
adjustments. Avoid removing the thumbscrews from the UPP Puller NXT Arm.
Figure 7: Mounting the UPP Puller NXT
Assembling the UPP Puller NXT Stand
To assemble the Puller Stand (UPP1006), prepare one 6mm and one 4mm HEX L-KEY.
Connect the Pole Assembly to the H-Base Assembly using the provided Washer M8, Split
Washer M8, and Screw M8. Use the 6mm HEX L-Key to secure the screw (Figure 8).
Figure 8: Assembling the UPP Stand
Yellow Bushing
UPP Puller NXT Arm Clamp Insert
Pole Clamp
Knob Screw
Thumb Screw
Thumb Screw
Thumb Screw
UPP Puller Arm
Status DRAFT Effective