Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Introduction
NXT Go Owner’s Manual, LBL-00145, MAN2030 12
Introduction
The LABORIE NXT Go system is a partially wireless capable system providing mobility and
ease-of-use in the field of Urodynamics. It allows studies to be performed with mountable
modules and is controlled by the LABORIE Synergy software. The wireless and battery-
powered features allow for improved system setup and use. For information on warranty
and terms and conditions, visit http://www.laborie.com/terms-and-conditions/.
Figure 1: NXT Go
1.1 Intended Use
The NXT family are medical device systems used for Urodynamics and pelvic floor
assessment. These systems can display, record, and store data such as vesical, urethral,
and abdominal pressures, urine flow and volume, and pelvic floor EMG from the patient for
diagnostics purposes only.
1.2 Indications of Use
The NXT Urodynamics System is indicated for urologic diagnostic testing to aid in the
diagnosis of urine storage and voiding disfunction diseases including:
Urinary incontinence and retention
Bladder outlet obstructions
Neurogenic bladder dysfunction
Other complex voiding/urine storage problems
This device is indicated for use under the direction of licensed and trained health care
professionals.
Status DRAFT Effective