Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Appendix
NXT Go Owner’s Manual, LBL-00145, MAN2030 113
Type BF Applied Part: N/A
External Materials: Dow Corning QP1-250, Cycoloy C6200-111,
Elastosil 3003/30 A/B, Gold-plated Brass, Loctite 401 & 242
IMPORTANT: LABORIE cannot guarantee the IP47 rating unless
the vent plug is inserted into the open vent hole.
UPP Puller NXT
P/N: UCX2001
Dimensions: 18”(45.7cm) L X 2.5”(6.4cm) W X 4.5”(11.4cm) H
Weight: 1.8 lbs. (0.82kg)
Arm extension: 32” (81.3cm)
Speed: 0 to 2 mm/s
IP Rating Compliance: IP54
Supported catheter sizes: 4.5-12 French
External materials: Cycoloy C6200-111, Aluminum 6061-T6,
POM-C, Dow Corning QP1-250, Stainless Steel, TPE,
Fluoroelastomer Rubber
Remote NXT
P/N: RCX2001
Dimensions: 65mmx36mmx119m
Weight: 100g
Internal Power Supply: 3x AAA batteries
IP Rating Compliance: IPX0
Type BF Applied Part: N/A
External Materials: Cycolac GPM5500S, Autotex 2F 157
Bluetooth Dongle
P/N: BTX2001
External Power Supply: 5VDC, 35mA max
IP Rating Compliance: IPX0
Type BF Applied Part: N/A
Accessories
External Materials
Funnel: Cycolac Resin, Acrylonitrile-butadiene-styrene
terpolymer
Beaker: Polypropylene
Commode: Powder-coated Steel and Plastic
EMG Cable (CAB1091, CAB1092): Polyamide and Thermoplastic
Elastomer
EMG Cable (CAB1103, CAB1104): PVC, Polyolefin, PA
Table 15: Equipment Specifications
Status DRAFT Effective