Owner's Manual
Table Of Contents
- 1 Introduction
- 2 Quick Start
- 2.1 Setting Up the Equipment
- 2.2 Gathering Supplies and Equipment
- 2.3 Preparing the Urocap NXT
- 2.4 Preparing the NXT Go Pump Hub
- 2.5 Preparing the Roam NXT
- 2.6 Preparing the UPP Puller NXT (Optional)
- 2.7 Setting Up Consumables and Preparing the Patient
- 3 How to Perform a Study
- 4 Synergy Software
- 5 Maintenance and Service
- 5.1 Cleaning and Disinfection
- 5.2 Preventive Maintenance
- 5.3 Verifying Calibration
- 5.4 Configuration
- 5.5 Computer Virus Protection
- 5.6 Disposing of Product After Use
- 5.7 Environmental Consideration of Waste Disposal
- 5.8 Backups
- 5.9 Troubleshooting Guide
- 6 Hardware
- 7 Appendix
Hardware
NXT Go Owner’s Manual, LBL-00145, MAN2030 107
6.9 UPP Puller NXT
The UPP Puller NXT supports the completion of Urethral Pressure Profile Studies. The UPP
Puller NXT consists of the motor, nose, arm, and pole clamp. The UPP Puller NXT comes
with a wall charger and the UPP Puller NXT Cable for charging or pairing. The Puller NXT
pole clamp allows the UPP puller to be mounted on the UPP Stand or IV Pole. Refer to
Figure 89 for an overview of important parts and controls.
Figure 89: UPP Puller NXT Key Parts and Controls.
UPP Puller NXT – Pairing
Use the UPP Puller NXT Connector Cable with the USB to binder adapter cable to connect
the UPP Puller NXT to the NXT Go laptop PC. The UPP Puller NXT will power on and will
appear in the Synergy Device Manager window. Once the Bluetooth connection is
established the cable can be disconnected for wireless use.
UPP Puller NXT – Charging the Battery
Charge the UPP Puller NXT by using the supplied wall charger and the UPP Puller NXT Cable.
Attach the binder connector to the connector on the wall charger.
Connect the wall charger to a power supply.
Attach the UPP Puller NXT Cable to the Cable Connector located on the UPP Puller
NXT Motor.
Table 14 indicates the different statuses for the UPP Puller NXT and its battery. The device
battery shall charge from “very-low” to “charged” in less than 4 hours when in charge only
mode or within 8 hours if charging while acquiring data. “Charged” is battery capacity
sufficient for more than or equal to one hour of recording and “very-low” is battery capacity
sufficient for less than one hour of recording. Always connect the UPP Puller NXT to the wall
charger at the completion of working hours to ensure full charge for the next study period.
If the UPP Puller will not be used for an extended period, ensure to power off the device. To
power off the device, press and hold the Power button until the LED light turns off.
UPP Arm Clip
UPP Puller NXT Arm
Pole Clamp
UPP Stand
Stand Mounted UPP Puller NXT
UPP Puller NXT
Motor
Carriage
Catheter Clamp
Catheter Guide
Nose Locking Mechanism
Nose
Cable Connector
Power Button
Arm Thumb
Screw
UPP Puller
NXT Arm
Status DRAFT Effective