Instruction Manual
Table Of Contents
Instruction Manual | 1
1. Introduction
The pipet controller is a device intended for general laboratory use only, for pipetting
liquids with the use of measuring pipets. It can work with all types of glass or plastic
pipets in the volume range from 0.5 mL to 100 mL. Two dispense modes permit
selection of dispensing intensity depending on the user’s needs. The selected setting
of the pipet controller mode is shown on the display (Figure 1E).
Figure 1 shows the external parts of the pipet controller with a description of the
materials used. Display indicators are shown in Figure 2.
2. Safety Information
Use of this product in any manner not specied by the manufacturer may impair
the safety protection provided by the equipment and may result in physical damage,
personal injury, and/or errors in pipetting of liquids. Please read all operating
instructions in this manual prior to use of this equipment.
This symbol indicates a potential risk and alerts you to proceed with
caution.
Using the device inconsistently with the operating instructions may result in
damaging the device.
The device should be serviced only at an authorized service center, otherwise the
manufacturer will be relieved from any liability under the warranty.
Only original spare parts and accessories, recommended by the manufacturer, shall
be used.
Only the original charger, supplied by the manufacturer, shall be used for charging
the batteries.
In case of incorrect functioning of the pipet controller, work shall be stopped. The device
shall be cleaned according to Section 9 and sent for repair to an authorized service center.
In the case of mechanical damage to the casing, the device shall be immediately
sent for repair to an authorized service center.
The use of excessive force during work shall be avoided.
WARNING:
During the work with the pipet controller, general safety regulations
regarding risks related with laboratory work should be observed.
Protective clothing, goggles, and gloves should be worn.
The pipet controller shall be used only for measuring liquids in conditions
specied by the manufacturer, which are limited due to the chemical and
mechanical resistance of the device, as well as the user safety.
The information and instructions provided by the manufacturers of the
reagents must be observed.
NOTE: The pipet controller is equipped with liquid vapors exhaustion system which
protects against corrosion to ensure long instrument life.