User Manual

ManualsBrandsLabnet ManualsEquipmentAccuBlock Digital Dry Baths (D1100 and D1200)

Instruction Manual

Digital Dry Bath

Models D1100 and D1200

Labnet International

PO Box 841

Woodbridge, NJ 07095

Phone: 732 417-0700

Fax: 732 417-1750

email: labnet@labnetlink.com

April 2003

Summary of content (4 pages)

PAGE 1
Instruction Manual Digital Dry Bath Models D1100 and D1200 Labnet International PO Box 841 Woodbridge, NJ 07095 Phone: 732 417-0700 Fax: 732 417-1750 email: labnet@labnetlink.
PAGE 2
1.0 General Specifications Temperature Range Temperature display resolution Temperature uniformity Temperature accuracy Control I/O Dimensions (W x D x H) / Weight Electrical requirements: D1100 115V D1100 230V D1200 115V D1200 230V Ambient +5C to 150C 0.1C 4 digit LED +/-0.2C (at 37C in block) +/-0.3C PI Microprocessor controller RS232 unidirectional 20 x 26.5 x 8.3 cm 2.2 kg 115V, 50/60Hz, 0.8A, 230V, 50/60Hz, 0.4A, 115V, 50/60Hz, 1.2A, 230V, 50/60Hz, 0.6A, Fuse 1.5A Fuse 1.5A Fuse 2.0A Fuse 2.2A 2.
PAGE 3
5.0 Operation Power the unit up with the On / Off switch at the back of the unit. The unit powers up in set mode. Use the UP arrow and DOWN arrow keys to set the temperature to the desired operating temperature. Press the “START” key and the unit will begin heating to the set point. The unit remembers the last set temperature at power down. However, the “START” key must be pressed to cause the unit to start heating to that set temperature.
PAGE 4
6. The unit will then begin to automatically adjust its operating temperature to your original set point with the re-calibration factor included. Allow sufficient time for the unit to re-equilibrate and then again compare the thermometer or sensor reading to the calibrated display. They should closely match. If not, repeat the calibration procedure. * Thermometers used for calibration purposes should have a written calibration certificate and be traceable back to NIST or some other certified body.