User guide

POTASSIUM
HYPOCHLORITE
SULPHUROUS
SODIUMCHLORIDE
TARTARIC
SODIUM
HYPOCHLORITE
Operation
1. Connectthesterilisertoanalternatingcurrentsupplyofvoltagespecifiedontheratingplate.
DANGER:THISSTEAMSTERILISERMUSTNOTBECONNECTEDTOADIRECTPOWERSUPPLY
2. Turn the simmerstat up as required and switch the MAINS on and check the indicating lamp
isilluminated.
3. Anindicatinglampnexttothesimmerstatwillilluminatewhentheheatersareoperating.
Maintenance
The cabinet is finished with stainless steel and to maintain appearance should be wiped over with a
nonabrasivecleanser.
Theinteriorisalsostainlesssteelandmaybecleanedwithasolvent.
Thefalsebottomcanberemovedtoallowcleaningaroundtheelementandcontrollersensor.
A fixed gabled lid is fitted and the hinge on the back should be kept clean and free from foreign
objectstomaintaineasyopening.
Troubleshooting
SYMPTON
REMEDY
NoPower
(IndicatorLightisoff)
1. Check steriliser is plugged in and power
switchedon.
2. Ensure mains power supply point is
functioning by using a test appliance on
powersocket.
3. CheckinternalRCDhasnottripped.
Failuretoheatormaintaintemperature
(Indicatorlightison)
1. Ensuresimmerstatisturnedon
2. Ensure the manual reset button is
depressed.
If the fault cannot be found call your distributor or the manufacturer quoting the serial number of the
steamsteriliserfromthemanufacturerslabel.
DeclarationofConformity
Eachproductisthoroughlyinspectedandtestedtonotonlyensurethatitmeetsthespecifications
provided,buttoalsomeetAustralianElectricalStandardAS3820andEMCStandard
AS/NZ1044:1995,andthereforebeingaccreditedwithaCTicklabel.
3LaboratoryEquipmentPtyLtdInstructionManual–SteamSteriliser2013ver1.0