User Manual

TroubleShooting
SYMPTOM
REMEDY
NoPower
(IndicatorLightisoff)
1. Check the water bath is plugged in and
powerswitchedon.
2. Ensure mains power supply point is
functioning by using a test appliance on
powersocket.
3. CheckinternalRCDhasnottripped.
Failuretoheatormaintaintemperature
(Indicatorlightison)
1. Ensure the temperature controller set
pointisaboveambient.
2. Check the safety controller fitted is above
themaincontrollersetting.
3. Cutoutbuttonhaspoppedout(iffitted).
If the fault cannot be found call your distributor or the manufacturer quoting the serial number of the
unitfromthemanufacturerslabel.
DeclarationofConformity
Each product is thoroughly inspected and tested to not only ensure that it meets the specifications
provided, but to also meet Australian Electrical Standard AS3820 and EMC Standard
AS/NZ1044:1995,andthereforebeingaccreditedwithaCTicklabel.
LaboratoryEquipmentPtyLtdInstructionManual–CalibrationBottleTestingBathPage4