User Manual



POTASSIUM
HYPOCHLORITE
SULPHURIC




POTASSIUM
HYPOCHLORITE
SULPHUROUS


SODIUMCHLORIDE
TARTARIC


SODIUM
HYPOCHLORITE








Operation
1. Connect the heating block to an alternating current supply of voltage specified on the rating plate               
mountedonthesideorrearofthechamber.
DANGER:THISUNITMUSTNOTBECONNECTEDTODIRECTCURRENTSUPPLY
1. Turnonthemainsandchecktoseethattheilluminatinglampisilluminated.
2. Set the target temperature or set point temperature using the up and down arrows on the front of                 
thecontroller.
3. Final adjustment of the temperature controller may be required after the heating block has             
reached operating temperature and this should be checked with a suitable thermometer located            
intheheatingblock(Athermometerisnotsuppliedwiththeunit).

TroubleShooting

SYMPTOM
REMEDY
NoPower

(IndicatorLightisoff)






1. Check heating block is plugged in and      
powerswitchedon.

2. Ensure mains power supply point is     
functioning by using a test appliance on      
powersocket.

3. ChecktheinternalRCDhasnottripped.


Failuretoheatormaintaintemperature

(Indicatorlightison)
1. Checkthetimerissetcorrectly.

2. Checkthetimerisreset(turnoff/on)

3. Ensure the temperature controller set    
pointisaboveambient.

4. Check the safety controller fitted is above      
themaincontrollersetting.

If the fault cannot be found call your distributor or the manufacturer quoting the serial number of the                 
unitfromthemanufacturerslabel.


3
LaboratoryEquipmentPtyLtdInstructionManual–HeatingBlock 