User Manual



InputPower
Usetheproductwiththespecifiedinputpowervoltage.
For applying power, use the AC power cable provided. The shape of the plug differs             
according to the power voltage and areas. Use the cable, which is suitable for the line              
voltageused.



Fuse
With products with a fuse holder on the exterior surface, the fuse can be replaced with              
anewone.
When replacing a fuse use the one, which has appropriate shape, ratings, and           
specifications.



Cover
There are parts inside the product, which may cause physical hazards. Do not remove            
the external cover. If the cover must be removed, contact your LABORATORY          
EQUIPMENTPTYLTDagentinadvance.


Installation
When installing product be sure to observe Installation Precautions described in this          
manual.
To avoid electrical shock connect the protective ground terminal to electrical ground          
(safetyground).
When applying power to the products from a switchboard, be sure work is performed            
by a qualified and licensed electrician or is conducted under the direction of such a             
person.
BesuretousetheACpowercableprovided.



Relocation
Turnoffthepowerswitchandthendisconnectallcableswhenrelocatingtheproduct.
Use two or more persons when relocating a product which weights more than 20kg.            
The weight of the product can be found on the rear panel of the product and/or in this                
operationmanual.
Use extra precautions such as using more people when relocating into or out of            
present locations including inclines or steps. Also handle carefully when relocating tall          
productsastheycanfallovereasily.
Besuretheoperationmanualisincludediftheproductisrelocate.



Maintenance
To avoid electrical shock, be absolutely sure to unplug the AC power cable or stop             
applyingpowerbeforeperformingmaintenanceorchecking.
Do not remove the cover when performing maintenance or checking. If the cover must            
beremovedcontactyourLABORATORYEQUIPMENTPTYLTDagentinadvance.
To maintain performance and safe operation of the product, it is recommended that           
periodicmaintenance,checking,cleaning,andcalibrationbeperformed.



Service
Internal service is to be done by LABORATORY EQUPMENT PTY LTD service          
engineers.
If the product must be adjusted or repaired contact your LABORATORY EQUIPMENT          
PTYLTDagent.


1.Intendeduseoftheapparatus.

Laboratory shakers are used in biological experiments to blend or agitate samples within flasks or              
tubes. This model is designed for culturing microbes and further for culturing, mixing, extracting             
andmanipulatingmicrobiologicalandplanttissues.
Our shaker model has an agitation platform attached. The platform has simple flask clamps             
LaboratoryEquipmentPtyLtd–OperationManualJUSRCShakerPage6