Instruction Manual

Installation
When installing products be sure to observe Installation Precautions
describedinthismanual.
To avoid electrical shock, connect the protective ground terminal to electrical
ground(safetyground).
When applying power to the products from a switchboard, be sure work is
performed by a qualified and licensed electrician or is conducted under the
directionofsuchaperson.
BesuretousetheACpowercableprovided.
Relocation
Turn off the power switch and then disconnect all cables when relocating the
product.
Use two or more persons when relocating the product which weights more
than 20 kg. The weight of the products can be found on the rear panel of the
productand/orinthisInstructionManual.
Use extra precautions such as using more people when relocating into or out
of present locations including inclines or steps. Also handle carefully when
relocatingtallproductsastheycanfallovereasily.
BesuretheInstructionManualbeincludedwhentheproductisrelocate
Maintenance
To avoid electrical shock, be absolutely sure to unplug the AC power cable or
stopapplyingpowerbeforeperformingmaintenanceorchecking.
Do not remove the cover when performing maintenance or checking. If the
cover must be removed, contact your LABORATORY EQUIPMENT PTY LTD
agentinadvance.
To maintain performance and safe operation of the product, it is recommended
thatperiodicmaintenance,checking,cleaning,andcalibrationbeperformed.
SERVICE
Internal service is to be done by LABORATORY EQUIPMENT PTY LTD  
serviceengineers.
If the product must be adjusted or repaired, contact your LABORATORY
EQUIPMENTPTYLTDagent.