User Manual

TroubleShooting


SYMPTOM
REMEDY
NoPower

(IndicatorLightisoff)






1. Check the bath is plugged in and power       
switchedon.

2. Ensure mains power supply point is     
functioning by using a test appliance on      
powersocket.

3. CheckinternalRCDhasnottripped.


Failuretoheatormaintaintemperature

(Indicatorlightison)
1. Ensure the temperature controller set    
pointisaboveambient.

2. Check the safety controller fitted is above      
themaincontrollersetting.

3. Cutoutbuttonhaspoppedout.

If the fault cannot be found call your distributor or the manufacturer quoting the serial number of the                 
unitfromthemanufacturerslabel.


DeclarationofConformity
Each product is thoroughly inspected and tested to not only ensure that it meets the specifications               
provided, but to also meet Australian Electrical Standard AS3820 and EMC Standard           
AS/NZ1044:1995,andthereforebeingaccreditedwithaCTicklabel.

LaboratoryEquipmentPtyLtdInstructionManual–OilBathPage