User Manual

Introduction
Congratulations on the choice of an Australian made quality product. Labec products are            
manufactured, tested and calibrated to meet published standard specifications under our strict           
qualityassuranceguidelines.

This Instruction Manual is for the guidance of operators of Labec Oil Baths and should be read                
beforethebathisconnectedtotheelectricitysupply.

It is hoped that this manual will supply all the information that the customer should require for                
satisfactory operation of the bath. If, however, there are any questions that remain unanswered then              
thecustomershouldcontactourServiceDepartment.

Unpacking
Remove all packing and protective wrapping from both interior and exterior of the bath. Check the               
bath for the possible transit damage. Ensure all ordered accessories are present. If any physical              
damage or shortages are evident, do not discard the packaging material until the bath is inspected               
bythedistributor,agentormanufacturer.
NOTE: All claims for shortage or damage must be made within fourteen days (14) from              
delivery.
Subject to our standard published conditions of sale, we have reasonable grounds to believe that we               
have ensured, so far as is reasonably practical, that the products listed in our catalogue and               
brochures have been designed and constructed so as to be safe and without risk to health when                
properly installed and used in their environment by appropriate and trained personnel, and where             
applicable,inaccordancewithourpublishedinstructions.

Installation
Electrical
This equipment must be tagged and tested according to AS/NZS3760:2010 prior to use and             
thereafteronaregularbasisdependentupontheenvironment.

It is preferable to locate the bath close to a power point and recommended that double adaptors are                 
not used. Check the total wattage if connecting to multipoint outlets. Check the rating plate for               
power requirements. Installation is to be carried out by a qualified electrician in accordance with the               
powerrequirementsoftheproductspecifications.

Location
Selectalocationfreefromdraughtandawayfromdirectsunlightorotherheatsource.

TemperatureControl
LABEC Oil baths are fitted with a digital temperature controller as per Appendix A, connected to the                
element.Thebathhasbeenstringentlytestedbeforeshipmenttoensureallisinworkingorder.

DescriptionofControls
AdjustthetemperaturecontrollerasperAppendixA.Anorangeheaterlightwillilluminatewhen
powerisbeingsuppliedtotheelements.









LaboratoryEquipmentPtyLtdInstructionManual–OilBathPage