Owner's manual

Operation
1. Connectthewaterbathtoanalternatingcurrentsupplyofvoltagespecifiedontheratingplate.
2. Ensure the water level is above the elements. On boiling baths connect the constant level device to a                 
watersupplyanddrain.

DANGER:THISWATERBATHMUSTNOTBECONNECTEDTOADIRECTPOWERSUPPLY

3. Switch the MAINS on then Turn the simmerstat/thermostat or temperature controller up using the up or               
downkeysonlyasrequired.
4. Anindicatinglamp‘OP1’willflashwhentheheatersareoperating.
5. Ensure the manual reset over heat cut off (brown button below the controller) is set by pressing it in or that                    
the over temperature alarm AL4 is set above the desired operating temperature (depending on which is               
present).

SafetyOvertemperaturecutoffmanualresetbutton
If the water bath is fitted with a manual reset button, be sure this is depressed before use. If the water level is too                       
loworrunsouttheswitchwillpopoutandturntheheatersoffuntiltheresetisdepressed.

Ifthewaterbathisfittedwithaninbuiltoverheatsafetyalarmitmustbesettoslightlyabovethedesiredsetpoint
temperatureandwillpreventoverheating.ChangetheALM4valuetoslightlyabovethesetpointtemperatureasset
outintheinstructionpage.TheAlarmwillbeactivatedifthebathreachestheALM4valueorifthesensoris
brokenordamaged.Torestartthebathtoheat,acknowledgethealarmbypressingthepageandscrollkeys
simultaneously(lefttwokeysonkeypadtogetherfor1secondonly).

Maintenance
The casing is finished with stainless steel and to maintain appearance should be wiped over with a non abrasive                  
cleanser.
Theinteriorisalsostainlesssteelandmayalsobecleanedwithasolvent.

TroubleShooting

SYMPTOM
REMEDY
NoPower

(IndicatorLightisoff)






1. Check the water bath is plugged in and       
powerswitchedon.

2. Ensure mains power supply point is     
functioning by using a test appliance on      
powersocket.

3. CheckinternalRCDhasnottripped.
Failuretoheatormaintaintemperature

(Indicatorlightison)
1. Ensure the temperature controller set    
pointisaboveambient.

2. Check the safety controller fitted is above      
themaincontrollersetting.

3. Cutoutbuttonhaspoppedout(iffitted).

If the fault cannot be found call your distributor or the manufacturer quoting the serial number of the unit from the                    
manufacturerslabel.

DeclarationofConformity
Each product is thoroughly inspected and tested to not only ensure that it meets the specifications provided, but to                  
also meet Australian Electrical Standard AS3820 and EMC Standard AS/NZ1044:1995,and therefore being           
accreditedwithaCTicklabel.

3LaboratoryEquipmentPtyLtdInstructionManualBaths2013Ver1.01