Owner's manual

Introduction
Congratulations on the choice of an Australian made quality product. Labec products are manufactured, tested and
calibratedtomeetpublishedstandardspecificationsunderourstrictqualityassuranceguidelines.
This Instruction Manual is for the guidance of operators of Labec Water Baths and should be read before the water
bathisconnectedtotheelectricitysupply.
It is hoped that this manual will supply all the information that the customer should require for satisfactory
operation of the water bath. If, however, there are any questions that remain unanswered then the customer should
contactourservicedepartment.
Unpacking
Remove all packing and protective wrapping from both interior and exterior of the water bath. Check the water bath
for any possible transit damage. Ensure all ordered accessories are present. If any physical damage or shortages
are evident, do not discard the packaging material until the water bath is inspected by the distributor, agent or
manufacturer.
NOTE:Allclaimsforshortageordamagemustbemadewithinfourteendays(14)fromdelivery.
Subject to our standard published conditions of sale, we have reasonable grounds to believe that we have ensured,
so far as is reasonably practical, that the products listed in our catalogue and brochures have been designed and
constructed so as to be safe and without risk to health when properly installed and used in their environment by
appropriateandtrainedpersonnel,andwhereapplicable,inaccordancewithourpublishedinstructions.
Installation
Electrical
This equipment must be tagged and tested according to AS/NZS3760:2010 prior to use and thereafter on
aregularbasisdependentupontheenvironment.
It is preferable to locate the bath close to a power point and recommended that double adaptors are not used.
Check the total wattage if connecting to multipoint outlets. Check the rating plate for power requirements.
Installation is to be carried out by a qualified electrician in accordance with the power requirements of the product
specifications.EnsuretheunitisTagTestedpriortofirstpowerup.
Location
Selectalocationfreefromdraughtandawayfromdirectsunlightorotherheatsource.
CirculatingPump
If a circulating pump is fitted there will be two small holes at the end of the bath. The upper hole is the inlet and
sucks the water in and then pushes it out the lower outlet hole across the heating elements under the tray. Ensure
before the bath is ever turned on that the upper inlet holes are well covered at all times. Test the water pump is
circulating with your finger and if not you will need to push some water into the inlet hole using a hose or similar to
pushtheairlockoutofthepumpsystem.
TemperatureControl
LABEC water baths are fitted with either simmerstat/thermostat controls or temperature controller as per Appendix
A, connected to the element. The water bath has been stringently tested before shipment to ensure all is in
workingorder.
DescriptionofControls
Iftemperaturecontrollerorifasimmerstat/thermostatsetthedesiredtemperatureorheatinglevelbyturningthe
knobclockwiseoradjustingthetemperaturecontrollerasperAppendixA.Alightonthecontroller“OP1”will
illuminatewhenpowerisbeingsuppliedtotheelements.
1LaboratoryEquipmentPtyLtdInstructionManualBaths2013Ver1.01