User guide

Installation
13
Rinsing the Filter Pack cartridge
J
•
Let FILLING TANK mode run for a minimum of 2 hours with the Tank
Outlet Valve open and placed to the drain. This will completely rinse
the purification media inside the
Filter Pack cartridge.
NOTE:
for sensitive applications, it is recommended to leave the
system
in
FILLING TANK overnight to ensure complete rinsing of the RO
membrane.
•
Close the Tank Outlet Valve and connect it back to the system if
needed. The tank will start to fill up with water. It could take
approximately 1.5 to 2 hours to fill the tank
. When it is full, the
Display will indicate a full tank by illuminating the symbo
ls
representing the Tank Level
(see Section Understanding the Display) .
•
The Vent Filter needs to be installed. See Section Installation of the
Vent Filter
.