User Manual

Wash 1, Steam, Rinses 1 & 2, Dry Time +/- 1 minute

Wash 2, Final Rinse Time after reaching SP +/- 1 minute

Conductivity varies between 100 - 1200

Confirm operation of low detergent and acid rinse monitor

Detergent Dispense 18 - 22 ml

Rinse Aid Dispense 5 - 7 ml

5 Observe Wash Action – Water hits top of tank from spindles

INSP/TESTS No. CONDITIONS AND REQUIREMENTS INST/LCC# RESULTS PASS

6 Run rinse only to wet surfaces. Visual

After wash pump starts, place a wet towel across the overflow contacts.

Wash pump should stop and the washer should drain. Display should

show ALARM OVERFLOW.

Hi-Pot

1 1000V for 1 minute. Hi Pot Tester ____________

Final

1 Check for Leaks Visual

2 Unit must be Clean and Dry Visual

3 All parts in place in good condition Visual

4 Verify that thermostat on back of tank is installed properly. Visual

5 Make sure drain hose is routed over top of wash pump. Visual

6 Perform FACTORY RESET Visual