User Manual
Labconco Glassware Washer Service/Technical Manual
58
7. Position the new door fan at the holes, making sure the air flow is
correct (out), and then insert the holding screws.
8. Connect the wires from the door fan to the Wiring Harness.
9. Reconnect/turn on power to the unit.
10. Using Diagnostics check the function of the Door “cooling” fan.
Gasket Replacement
Door Removal
Before the two gaskets (baffle gasket and door gasket) can be removed and
replaced the washer’s door must be removed.
1. Remove the door, as described in Chapter 3: Getting Started, Connecting
the Power Supply in the Instructional Users Manual
.
CAUTION: Be careful not to release the cable hooks before you have unloaded
the door spring or the side panels may have to be removed to reattach the
door cables.
2. With the door cables off, lower the door to its opened position and
lift to pull it out.
3.
Tank Gasket
1. Remove the bad/damaged gasket by pulling it from its housing around the
outer edge of the tank.
NOTE: The unit may or may not have clips holding the two gaskets into place
Fig 1A). If it DOES, then those clips will need to be removed, saved, and
reinstalled when the new gasket is put into place.
2. The replacement rubber gasket will be cut longer than necessary. Place
one end of the gasket at the far bottom ledge of the washer (Fig 1C)
and push the new gasket firmly into place up one side, across the top
and then down the other side.
3. When the bottom of the second side is reached, the gasket will need to
be trimmed so that the new edge rests snuggly at the bottom of its
housing (Fig 1C).
Figure 33: Bottom front left corner
of washer tank. With the door off
you can find the clips and RTV
application used to hold the gaskets
into place. Circle A: There may or
may not be a clip holding the door
gasket in place. If there is, this must
be taken out to remove the damaged
gasket.
Circle B: The baffle gasket is held
in place by two clips on the outside
edges of the baffle/water deflector
and then sealed at the sides with
RTV. These measures must be
removed to replace the washer and
then reinstalled/reapplied in order to
form a water tight seal.
C: When replacing the door gasket,
make sure that the gasket goes to all
the way to the bottom of the tank on
both sides. The gasket will be cut
long, and must be trimmed back at
the end of installation.