User Manual

Labconco Glassware Washer Service/Technical Manual

SECTION IV:

Part Replacement

Once the root cause of a failure has been determined, it may be

time to replace parts. When major part replacement of the

various washer systems is required, use this section’s various

procedures for assistance.

Replacing the PC Board, Display Panel and Button Pad

The PC (timer) Board, Display Panel and Button Pad are all part of the

Control Module Interface. The PC Board is where the user inputs

settings and sets up a program; it’s also where they get information

from the timers and sensors in the washer. Use the procedures below

to access the control module and replace parts when there is a control

failure.

**Completely drain and disconnect electrical power to the unit before

proceeding with any of these instructions.

Accessing the Control Module

1. Open the washer’s door.

2. Remove the mounting screws on the door’s backside that secures the

grey, plastic Control Panel and the screws on the side of the door that

secure the front panel (this must be removed to pull off the controls).

3. Lift the door and remove the mounting screw that holds the plastic knob

to the door latch.

4. Pull the Control Panel from the door to access the Control Module.

5. Remove wiring pin connectors as necessary for the needed repairs.

Figure 14

Left: Door Assembly. The Arrows point to the position of the

machine screws that hold the Control Panel to the Doors Inner

Frame Panel.

Below: Control Module. The Yellow Circles indicate the five

mounting screws that hold the Control Module to the Control

Panel. The Green Circle shows where the PC Board’s Ribbon

Cable is fitted between the

askets and sealed with RTV.