User Manual

Labconco Glassware Washer Service/Technical Manual

2. Press and hold the ▼ button and close the handle of the washer by

sliding the door latch knob to the right. Hold for 5 seconds.

3. The display will show the SET UP screen.

4. The > on the left side will highlight VOLTAGE.

5. Press the ▼ button until the > highlights LIQ DETERGENT OPT

6. Press the ◄ or ► buttons to select “NO” and turn off the PC Boards

detergent level sensor.

7. When the machine is restarted for normal operation the Alarm(s) should

have been cleared.

DRAIN FAIL ALARM

This displays if water fails to completely drain during a normal drain

operation. Operation of the washer is cancelled at this time. The

alarm is silenced by opening the door.

Before undertaking these procedures please do the following

preliminary check. If you look in User’s Instructional Manual (pages

15 and 16), there are diagrams picturing how to plumb the drainage

lines. Make sure your unit is set up according to the manual and no

extra length of tubing has been added to what is supplied by Labconco.

BEFORE CALLING FOR SERVICE, DETERMINE THE FOLLOWING:

PCBoard logic revision on the display when the latch is shut:

______________

Line voltage:

______________

Cycle and Segment running when the problem occurred:

Figure 5: (left)

Front view of

glassware washer.

Circle “4”

indicates location

of where the

Drain Pump can

be found (see

Figure 4)

Figure 6: (right)

Side view of

glassware washer.

Circle “3”

indicates location

of where the

Drain Valve &

Pump can be

easily seen/found

(see Figures 3 &

4).