Owner's manual

Page 5 of 197
Section Five – Certification Procedures for the Type A2 Logic
Accessing the Certifier’s Menu 63
Adjusting the Blower Speed 63
Adjusting the Filter Gauge 64
Adjusting the Optional Inflow and Downflow Values 65
HEPA Filter Leak Test 65-73
If the Logic is contaminated 65-69
If the Logic is uncontaminated 69-73
Downflow Velocity 74-75
Inflow Velocity 75-76
Primary Inflow Method 75
Secondary Inflow Method 76-78
Work Area Air Cleanliness Test (optional) 79
Fluorescent Light Level (optional) 80
Noise Level (optional) 80
Vibration (optional) 81
UV intensity (optional) 81
Ground Fault Circuit Interrupter 82
Section Six – Certification Procedures for the Type B2 Logic
Accessing the Certifier’s Menu 83
Adjusting the Blower Speed 83
Logic Filter Life Gauge Operation and Resetting for Local Conditions 84
Adjusting the Inflow Velocity 84
Adjusting the Alarm Setpoint Velocity 85
Supply HEPA Filter Leak Test 85-88
Measuring the Upstream Concentration 85-86
Calculating an Upstream Concentration 86-87
Preparing the Logic for Supply HEPA Filter Leak Testing 87-88
Exhaust HEPA Filter Leak Test 89-90
Downflow Velocity 91-92
Inflow Velocity 92-95
Primary Inflow Method 92
Secondary Inflow Method 93-95
Total Exhaust Volume 96
Work Area Air Cleanliness Test (optional) 97
Fluorescent Light Level (optional) 98
Noise Level (optional) 98
Vibration (optional) 99
UV intensity (optional) 99
Ground Fault Circuit Interrupter 100