Owner's manual

Page 141 of 197
Electronics Module Access
The Electronics module is located on the top right side of the cabinet. To access the
module, do the following:
1. Unplug the Logic, either at the wall, or at the power cord inlet at the back of the
electronics module, as shown in Figure 9-2.
2. Remove the two 7/16-inch acorn nuts and lock washers that secure the module.
3. Tip the module on its side, and secure it so it does not fall.
Figure 9-2
Electronic Module Component Identification
The Electronics module contains the circuit breakers, the relay and power supply boards,
the fluorescent and optional UV ballasts, and the optional RS-232 board. These items
are shown in Figure 9-3.
Figure 9-3
Circuit Breakers
Fluorescent Ballast
UV Ballast
Power Supply Circuit Board (Upper)
Relay Board (Lower)