Instruction Manual

Chapter 3: Getting Started
Product Service 1-800-522-7658
7
Bulk Tray Dryer Components
Locate the model of Bulk Tray Dryer you received in the following table. Verify
that the components listed are present and undamaged.
Power Cords
Catalog # Description Volts Hz
6 Port
Manifold
1334500 1336100 1338000 1332600 1332700
7806020 Bulk Tray Dryer 115 50/60 X
7806021 Bulk Tray Dryer 115 50/60 X X
7806030 Bulk Tray Dryer 230 50/60 X
7806031 Bulk Tray Dryer 230 50/60 X X
7806040 Bulk Tray Dryer 230 50/60 X
7806041 Bulk Tray Dryer 230 50/60 X X
7806060 Bulk Tray Dryer 230 50/60 X
7806061 Bulk Tray Dryer 230 50/60 X X
7806070 Bulk Tray Dryer 230 50/60 X
7806071 Bulk Tray Dryer 230 50/60 X X
Plus the following:
Part # Qty. Component Description
7594900 1 User’s Manual
1880712 4 Screw ¼-20 x .75
1905621 4 Nut ¼-20
1911416 8 Washer ¼
If you did not receive one or more of the components listed for your Bulk Tray
Dryer, or if any of the components are damaged, contact Labconco Corporation
immediately for further instructions.
Setting Up Your Bulk Tray Dryer
After you verify receipt of the proper components, move your Bulk Tray Dryer to
the location where you want to install it. Then, follow the steps listed below.
Installing the Tray Dryer on the Freeze Dry System
The following tools are required to install the Bulk Tray Dryer onto a FreeZone
Freeze Dry System: Flat blade screw driver or 5/16" socket and a 7/16" wrench
or socket.
Remove the four plastic hole plugs from the top of the Freeze Dry System on
which the Bulk Tray Dryer is to be mounted. If the Freeze Dry System has a flat
gasket around the 3.0 inch vacuum port, remove it. Loosen both clamps on the
lower connection hose and slide the hose upward so the bottom of the hose is
above the lower edge of the stainless steel tube. Snug both clamps on the hose to
hold them in place.