Data Sheet

LABCENTER ELECTRONICS LTD.

Move the mouse along to the left and then left click the mouse once to place an ‘anchor’.

Move the mouse up, left click to place an anchor, then right, left click to place an ‘anchor’

and finally down onto the wire between the op-amp output and resistor.

This technique constrains the follow-me algorithm and provides greater control during wire

placement. If at any time during placement you change your mind and wish to remove an

anchor simple right click the mouse once. Finally, if you want to completely disable the wire-

auto-router and, for example, place a wire at 45 degrees, simply hold the CTRL button down on

your keyboard during placement.

Gateswap

Now that we have a multi-element placed (LM358 dual op-amp) it's a good time to look at gate-

swapping on the schematic. The reference for a multi-element part reflects both its part

reference (e.g. U4) and also its gate element identifier (e.g. A) as shown below.