Data Sheet

Schematic Capture
31
This will cause netlist errors when working in the PCB module. If, however, you re-annotate
using the new button on the edit component you are guaranteed a unique part reference.
The 'New' button will automatically assign a new reference
Similarly, the Global Annotator (discussed later in the tutorial) will always avoid duplication of
part references.
As well as the ability to hide part labels you can move them to a more convenient place. This is
commonly used where you might want to place a wire over the current position of the label and
need to free up some screen space. We will try this now with the 'R2' and the '10k' labels on the
pull up resistor, moving them across to the other side of the component body.
Start by selecting the resistor. Now point at the label 'R2' and with the left button depressed,
drag it to its new position to the left of the component body. Then do the same with the '10k’
label.
Dragging a reference