Data Sheet

LABCENTER ELECTRONICS LTD.
204
Click on the I2C analyser in the parts bin to select it and then place it on the schematic in the
usual way. For ease of wiring, you'll want to drop it underneath the temperature sensor.
Next, we need to wire up the pins. Note that the cursor turns green on both a starting and
stopping point for a wire. The wiring procedure is therefore to position the mouse over the
starting point (the pin on the I2C debugger) until the cursor turns green, left click to start
placement, move mouse to destination point (cursor turns green) and finally left click to
terminate placement. Use this technique to connect both the SCL and the SDA lines to the I2C
bus.