Data Sheet

LABCENTER ELECTRONICS LTD.
134
Selecting the Bottom Copper layer
The processor is some distance from the connector and the easiest path would seem to be
down and along the bottom of the board. Begin placing the track by left clicking on pin 1 on the
connector and then moving the mouse downwards
Routing on Bottom Copper
When we get near the bottom of the board, left click the mouse to place anchors and guide the
mouse to the left. To maximise space on the board you can route across the bottom of the
board with the mouse over the board edge graphic - this will hug the track to the absolute edge
of the board leaving only the Edge Clearance between the two.
Tracks will hug the board edge
Once you get near the U1 IC bring the track up just past the right hand pads of the processor
footprint.