Manualshelf

Quick Start Guide

ManualsBrandsLab Gruppen ManualsPower Amplifiers5000W Amplifier with 4 Flexible Output-Channels, Lake Digital Signal Processing and Digital Audio Networking for Touring Applications
11121314151617181920
7. Installation
PLM+ SERIES Quick Start Guide rev 3.0.4
19
7.2. Mounting
PLM+ is made for mounting in 19 inch racks. Four screw holes are available for attachment of the amplier to the
racks front rack rail. This device has no top or bottom vents; therefore, units may be stacked directly on top of
one another. Sucient space should be available at the rear to accommodate connectors and cables. In addition,
allowance must be made for cable or loom bends within a rack.
7.2.1. Rear Mounting
Two rear support brackets, along with associated mounting hardware, are included with the PLM+ device. It is
strongly recommended that these are used wherever possible. Fit the brackets to the vertical rails at the rear of
the rack. The support brackets are reversible and may be tted to point either to the front or rear of the rack; the
proper orientation depends on the rack depth and position of the rear rack rails.
Rear support bracket with mounting hardware
Rear support bracket mounted for xed Rear support bracket mounted for removable
installation and bracket pointing forward installation and bracket pointing towards back