Data Sheet

W W W . L A B G R U P P E N . C O M
Specifications LUCIA 60/2
Item no. TDS-LUCIA602_V1 - 09.25.2017
General
Number of powered channels
2
Total output all channels driven
60 W
Max output voltage per channel
1)
21.9 V peak
Max. output current per channel
3.9 Arms
Max. Output Power (all ch.’s driven)
2 ohms
30 W
4 ohms
30 W
8 ohms
30 W
16 ohms
15 W
Performance
THD 20 Hz - 20 kHz at 1 W into 8 ohms
<0.3%
THD at 1 kHz and 1 dB below clipping
<0.2%
Signal To noise ratio into 8 ohms
>95 dBA
Channel separation (Crosstalk) at 1 kHz
>60 dBA
Frequency response
5 Hz - 22 kHz
Input impedance
10 kOhm
Input common mode rejection, CMR
40 dB
Gain, Sensitivity and Limiters
VPL for 8 ohm mode
21.9 V peak
VPL for 16 ohm mode
21.9 V peak
VPL for 4 ohm mode
15.5 V peak
VPL for 2 ohm mode
11 V peak
Sensitivity, balanced input
4 dBu / 1.23 Vrms
Sensitivity, RCA input
-2 dBu / 0.62 Vrms
Input headroom for clip, balanced
2)
12 dBu / 3.09 Vrms
Input headroom for clip, RCA
2)
6 dBu / 1.55 Vrms
Connectors and buttons
Input connectors (per ch.)
3-pin detachable screw terminals, electronically balanced
Input connectors (ch 1 & 2)
Unbalanced RCA type
Output connector (per ch.)
2-pin detachable screw terminal
GPI (power control input)
3)
2 channels of voltage sense type. 4 pins in a detachable screw terminal. Default for gain.
GPO (power state output)
3)
Contact closure type, 2 pins in a detachable screw terminal. Default for external monitoring of fault/protection/power off
RS232
Can be controlled and monitored by third parties via RS232 using both the GPI pins
USB
Cooling
stays below 2 × 6 W and the ambient temperature is below 25 C
Auto mode
The power state is controlled automatically with the audio signal
Level adjustment (per channel)
Front panel potentiometer, detented from -inf to 0 dB
Processing Features
Input processing block
4)
4 EQ sections per input
Mix matrix routing block
4)
2 in - 2 out mix-matrix controllable from GPI
Output processing block
4)
4 EQ sections (presets available for many loudspeakers)
User adjustable output look ahead limiter
ADLC (Ada
ptive ISO 226 compensation)
Latency from any input to any output
User adjustable from 9.15 to 137 ms
Power
Nominal voltage
100 - 240 VAC
Operating voltage
85 - 265 VAC
Standby consumption
<1 W
Mains connector
IEC inlet
Dimensions
W: 216 mm (8.5”), H: 44 mm (1.7”), D: 280 mm (11”)
Weight
1.9 kg (4.2 lbs.)
Finish
Black aluminum front and black steel chassis
Approvals
CE, CSA, CCC, PSE, FCC, ENERGY STAR
Note 1): Into 8 ohms and higher
Note 2): An analog soft limit will be engaged on the input above thi
s level to reduce the clip distortion
Note 3):
Note 4):
All specifications are subject to change without notice.