Data Sheet

WWW . L A B G R U P P E N . C O M
Specifications LUCIA 120/2M
General
Number of powered channels 2
Total output all channels driven 120 W
Max output voltage per channel
1)
31 V peak
Max. output current per channel 5.5 Arms
Max. Output Power (all ch.’s driven)
2 ohms 60 W
4 ohms 60 W
8 ohms 60 W
16 ohms 30 W
Performance
THD 20 Hz - 20 kHz at 1 W into 8 ohms <0.3%
THD at 1 kHz and 1 dB below clipping <0.2%
Signal To noise ratio into 8 ohms >98 dBA
Channel separation (Crosstalk) at 1 kHz >60 dB
Frequency response 5 Hz - 22 kHz
Input impedance 10 kOhm
Input common mode rejection, CMR 40 dB
Gain, Sensitivity and Limiters
VPL for 16 ohm mode 31 V peak
VPL for 8 ohm mode 31 V peak
VPL for 4 ohm mode 22 V peak
VPL for 2 ohm mode 15 V peak
Sensitivity, balanced input 4 dBu / 1.23 Vrms
Sensitivity, RCA input -2 dBu / 0.62 V
rms
Input headroom for clip, balanced
2)
12 dBu / 3.09 Vrms
Input headroom for clip, RCA
2)
6 dBu / 1.55 Vrms
Connectors and buttons
Input connectors (per ch.) 3-pin detachable screw terminals, electronically balanced
Input connectors (ch 1 & 2) Unbalanced RCA type
Line-level output connectors (ch. 3 & 4) 3-pin detachable screw terminals, electronically balanced
Output connectors (per ch.) 2-pin detachable screw terminals
GPI (power control input)
3)
2 channels of voltage sense type. 4 pins in a detachable screw terminal. Default for gain.
GPO (power state output)
3)
Contact closure type, 2 pins in a detachable screw terminal
Default for external monitoring of fault/protection/power off
RS232 Can be controlled and monitored by third parties via RS232 using both the GPI pins
USB
Cooling Can stay off if the sustained power average stays below 2 x 6 W and the surrounding
temperature is below 25 degrees C
Auto mode The power state is controlled automatically with the audio signal
Level adjustment (per channel) Front panel potentiometer, detented from -inf to 0 dB
Processing Features
Inputs processing block
4)
4 EQ sections per input
Mix-matrix routing block
4)
4 in - 4 out mix-matrix controllable from GPI
Outputs processing block
4)
4 EQ sections per output (presets available for many loudspeakers)
User adjustable output look ahead limiter
ADLC (Adaptive ISO 226 compensation)
Two line level outputs
5)
Each capable of driving 10 LUCIA devices in parallel
Latency from any input to any output User adjustable from 9.15 to 137 ms
Power
Nominal voltage 100 - 240 VAC
Operating voltage 85 - 265 VAC
Standby consumption <1 W
Mains connector IEC inlet
Dimensions
W: 216 mm (8.5”), H: 44 mm (1.7”), D: 280 mm (11”)
Weight 1.9 kg (4.2 lbs.)
Finish Black aluminum front and black steel chassis
Approvals CE, CSA, CCC, PSE, FCC, ENERGY STAR
Note 1): Into 8 ohms and higher
Note 2): An analog soft limit will be engaged on the input above this level to reduce the clip distortion
Note 3):
Note 4):
Note 5):
All specifications are subject to change without notice.
Item no. TDS-LUCIA1202M_V3 - 09.25.2017