Brochure

Source Combinations
• 1 x Stereo
• 2 x Mono
External
Source
Select
External
Volume
Control
Additional speakers may be
connected depending on the speaker
impedance/power and application/size
of room, etc
Stereo setup
Typical Configuration
Above is shown a typical stereo application, with
inputs via the RCA connectors, typically from
a local user source such as mp3 player, laptop,
CD player or DJ mixer. These inputs are shared
on channel 1 and 2 with the Euroblock/Phoenix
connector. Powered outputs are use the same
connector type with each LUCIA capable of driving
at maximum power down to 2 ohms. As shown, this
gives the LUCIA the potential of powering up to
8 loudspeakers on each channel if using 16 ohm
devices – for a total of 16 loudspeakers on a single
ultra-compact low-impedance amplifier! Typically,
these would be high quality ceiling-mount or
compact surface-mount speakers. Many such suitable
products are available from Tannoy Professional.
GPIO provides potential for remote control, either
integrating with wider system control framework
(eg. Crestron or AMX) or simple wall-mounted user
controls for volume and/or source selection
(if 2 x mono sources).
LUCIA offers remarkable flexibility, with inherent simplicity in setup. Illustrated above and right are typical configurations, for both the 2-input ‘base’ models
and the 4-input ‘Matrix’ models.