Data Sheet

Specifications E 5:4
Item no. TDS-E5:4_V1 - 26.01.16
General
Number of channels 4
Total output all channels driven 500 W
Peak output voltage per channel 100 V / 70 Vrms
Max. output current 9.9 Arms
Max.OutputPower(all ch.’s driven)
2 ohms N.R.
4 ohms 125 W
8 ohms 125 W
16 ohms 125 W (requires the “70 V” mode for the RSL, “Lo-Z” gives 63 W)
70 V 125 W
100 V Can deliver 125 W to a 100 V load tapped at 250 W
Performance
THD 20 Hz - 20 kHz for 1 W <0.1%
THD at 1 kHz and 1 dB below clipping <0.05%
Signal To Noise Ratio >112 d BA
Channel separation (Crosstalk) at 1 kHz >70 dB
Frequency response 2 Hz - 40 kHz
Input impedance 20 kOhm
Common Mode Rejection (CMR) 50 dB
Output impedance 25 mOhm
Gain,SensitivityandLimiters
Limit and gain switch defining limit and gain (per channel) 2 pos: Lo-Z and 70 V
VPL for 70 V mode 100 V
VPL for Lo-Z mode 44.7 V
Sensitivity for stated power into 8 Ohm in Lo-Z mode 4 dBu
Sensitivity for 70.7 V out in 70 V mode 4 dBu
Sensitivity for stated power into 4 Ohm in Lo-Z mode 1 dBu
Sensitivity for stated power into 16 Ohm in 70 V mode 0 dBu
Gain in 70 V mode 35.2 dB
Gain in Lo-Z mode 28.2 dB
Level adjustment (per channel) Rear panel potentiometer, from -inf to 0 dB
Connectorsandswitches
Input connectors (per ch.) 3-pin detachable screw terminals, electronically balanced
Output connectors (per ch.) 2-pin detachable screw terminals
High pass lter Fixed at 50 Hz, switchable per channel
Power control Can be used to go between standby and ON
GPI (power control input) Contact closure type, 2-pin detachable screw terminal, controls the power state
GPO (power state output) Contact closure type, 2-pin detachable screw terminal, for external monitoring of the power state
Cooling Two fans, front to rear airflow, temperature controlled speed
Power
Nominal voltage 100 - 240 VAC
Operating voltage 85 - 265 VAC
Standby consumption <1 W
Mains connector IEC inlet
Dimensions
W: 483 mm (19”), H: 44 mm (1 U), D: 381 mm (15”)
Weight
6 kg (13.2 lbs)
Finish
Dark grey aluminium front and black steel chassis
Approvals
CE, ANSI/UL 60065 (ETL), CSA, CCC, PSE, Energy Star
All specifications are subject to change without notice.
WWW.LABGRUPPEN.COM