Lake Controller Operation Manual Version 1.7.0

Lake Controller Operation Manual Rev 1.7.0
Designer Mode Menu Reference
237
Table 19-1: Designer Mode Security Examples
SCENARIO NAVIGATE TO
Factory Levels
Locked
Levels > Meter Options
The Adjust Factory button normally present is not
available until the base conguration le is unlocked.
Level Limits
Locked
Levels > Meter Options
The Level Limits button normally present is not available
until the base conguration le is unlocked.
The Input Delay
Max Level Limit is
set to zero.
Levels > Delay
Attempt to move the input delay fader, shown in
Designer Mode only. (In User Mode, this delay fader is
removed.)
XOVER/HPF/LPF
transferred and set
to View Only
EQ > XOVER (or HPF/LPF)
EQ is affecting the
audio, but cannot be
viewed
EQ settings stored in base conguration les cannot
be viewed, although an audio comparison can be made
between Module A and B to verify they are identical.
19. 2.1.5 Summary
Base conguration les enable low-level security allowing control over individual aspects of the system. The
system designer can ne-tune a speaker conguration or system EQ and protect the settings by hiding or
setting them as View Only.
The base conguration les can be stored and recalled into other Modules in the same system or in differ-
ent systems. This provides a starting point from which the Module can be ne-tuned by another designer or
user.
The I/O CONFIG screen displays the name of the
base conguration le that was originally recalled or
most recently stored. I/O CONFIG is located under
the MODULES menu.