Lake Controller Operation Manual

Lake Controller Operation Manual Rev 1.5.9
EQ/Levels Menu Reference
65
6.1.1 General Access
The EQ/LEVELS button accesses the following information:
▸ Module and Group Parametric EQ (PEQ)
▸ Module and Group Band Level EQ (BLEQ)
▸ Module and Group Graphic EQ (GEQ)
▸ Module and Group levels (gain, delays, limiters, etc.)
▸ Module crossovers and high-pass lter/low-pass lter (HPF/LPF) (Contour) or HPF/LPF only (Mesa EQ)
The EQ/Levels functions can be accessed by several methods from the following menu locations:
▸ HOME Tap a Module/Group icon once
▸ MODULES Select a Module/Group icon, then tap the EQ/Levels button
▸ GROUPS Select a Module/Group icon, then tap the EQ/Levels button
▸ SOLO/MUTE Select a Module/Group icon, then tap the EQ/Levels button
▸ I/O CONFIG Tap a section of the interactive block diagram
6.1. 2 Restricted Access
The Lake Controller provides security by allowing a system designer to hide parts of the system or set them
to View Only. This can be done globally in a system, or for individual Modules. This security specication
may affect the screens allowed to be displayed when accessing EQ/Levels. Please refer to chapter 19 for
further details.
6.1. 3 Group Adjustments
Group EQ and levels are in “view only” mode when viewing via a Module. To adjust Group EQ or levels,
access the Group EQ/Levels page via the Group icon.
Groups do not have a Xover or HPF/LPF page.
However, the Gang Xover/Aux/HPF/LPF functions,
available from the Groups menu, can be used to link
the Xover/Aux/HPF/LPF for all Modules in a Group.