Lake Controller Operation Manual

Lake Controller Operation Manual Rev 1.5.9
Firmware Update
303
For PLM+ and D Series, the rmware update utility must be able to read the Dante component before the
rmware update can start; ensure the network adapter selected for rmware update is on the same subnet
as Dante (169.254.x.x) and ensure the Lake Update Utility has full access through the rewall.
An hourglass will display with the text “Dante version...”; if this
does not complete within 30 seconds, press the Refresh Dante
button. If the issue continues, open the Dante Controller and
press “Reload Device Information”, or restart the computer.
.
6. Tap SELECT OLD and then UPDATE. A warning message appears.
Figure 26-4: Firmware Update Warning Message
7. Tap OK in response to the warning message. All selected devices are updated in parallel with the latest
rmware. A green tick indicates the rmware is already at the latest version, a percentage indicates the
update status for the devices currently being updated, and a red cross indicates the rmware is old and
is awaiting update or the device requires a power-cycle to complete the upgrade.
Figure 26-5: Firmware Update Status
8. Wait for all devices to be updated.
A message appears, indicating that you must restart the updated Frames. When the rmware is updated,
the warning advises that the mains power must be cycled (using the standby button on the Front Panel is
not sufcient). For the MY8-LAKE, please power-cycle the host device.