Operation Manual

15. Technical Specifications
D SERIES Lake Operation Manual rev 3.0.1
49
15. Technical Specifications
D 200:4L D 120:4L D 80:4L
General
Processing / Network Lake / Dante Lake / Dante Lake / Dante
Number of amplier channels 4 4 4
Total burst power all channels (share among channels with RPM) 20000 W 12000 W 8000 W
Max. Output Power (all ch.’s driven)
1)
2 ohms 4400 W 3000 W 2000 W
2.67 ohms 5000 W 3000 W 2000 W
4 ohms 4400 W 3000 W 2000 W
8 ohms 2300 W 1900 W 1500 W
16 ohms 1150 W 950 W 750 W
Hi-Z 70 V 3300 W 3000 W 2000 W
Hi-Z 100 V 4700 W 3000 W 2000 W
Max. Output power bridged mode (all ch.’s driven)
1)
4 ohms 8800 W 6000 W 4000 W
8 ohms 8800 W 6000 W 4000 W
16 ohms 4600 W 3800 W 3000 W
Max output power single channel (all models)
1)
2 ohms 4400 W
2.67 ohms 5900 W
4 ohms 4600 W
8 ohms 2300 W
16 ohms 1150 W
Hi-Z 70 V 3300 W
Hi-Z 100 V 4700 W
Amplier output modules (all models, all channels)
Peak output voltage 194 V
Max output current 67 A
Rational Power Management (RPM)
Share “total burst power” of the product freely among channels. Any channel can scale up to the “Max. output
power single channel”
Default voltage limitation (can be lifted with RPM conguration) 194 V 175 V 155 V
Protection features Current Average Limiter (CAL), Very High Frequency Protection (VHF), Direct Current Protection (DC),
Short Circuit Protection, Current-Clip Limiter, Voltage Clip Limiter, Temperature protection
Amplier platform
Inter Sample Voltage Peak Limiter (ISVPL) Congurable Peak voltage threshold and prole
Amplier gain Digital congurable amplier gain 22 - 44 dB
Pilot tone generation and analysis LoadPilot
Load impedance analysis
Yes
Temperature control Regulated fans and show must go on limitation (ATL, PTL)
Audio Performance (Amplier platform with digital input)
THD + N 20 Hz - 20 kHz for 1 W < 0.05 %
THD + N at 1 kHz and 1 dB below clipping < 0.04 %
Dynamic range > 114 dB
Channel separation (Crosstalk) at 1 kHz > 70 dB
Frequency response (1 W into 8 ohm, 20 Hz - 20 kHz) +/- 0.05 dB
Internal sample rate / Data path 48 / 96 kHz / 32 bit oating point
Product propagation delay AES 96 kHz / analog input 1.61 / 1.68 ms
Lake processing
Loudspeaker processing Up to 4 modules of Classic/linear-phase/FIR crossover, EQ, delay, LimiterMax™ - peak and RMS limiters
System tuning Group control with Raised Cosine™ MESA EQ™ asymmetric lters
Input redundancy / Matrix Automatic 4 level input redundancy / 4 input mixers
System integration Comprehensive 3rd party protocol over UDP Ethernet
Dante Audio Network
Dante I/O 8 x 8
Network topology / redundancy Flexible topology / Supports daisy-chained and Dual redundant networks
Sample rates / transport 48, 96 kHz / Uni + Multicast
Network latency 0.25, 0.5, 1.0, 2.0, 5.0 ms
Analog inputs
Inputs 4 high quality inputs with Iso-Float ground isolation
Maximum input / digital reference + 26 dBu / +21 dBu
Sampling rate / resolution 96 kHz / 24 bit
Input impedance balanced / unbalanced 20 / 10 kOhm
THD + N (typical at 1 kHz unweighted) 0.00022 %
THD + N (typical at 20 Hz and 20 kHz unweighted) 0.00033 %