Lake Controller Operation Manual Version 1.7.0

156
Lake Controller Operation Manual Rev 1.7.0
Modules Menu Reference
8.3 Label & Lock
From the Modules menu, tap LABEL & LOCK to view a submenu with functions to label a Module or Frame
and allow a system designer to lock Module and base congurations
8. 3.1 Module Label
The Module Label is a user-denable value at the bottom of the Module icon that identies the Module.
To label a Module:
1. Tap the desired Module icon on the MAIN page.
2. Tap MODULE LABEL, enter a Module name, and tap OK.
8.3.1.1 Dynamic Module Label
Figure 8-29: Dynamic Module Label enabled
By default, the Module Label changes to the name of a Module le recalled. The Dynamic Module Label
makes it possible to specify a Module Label, and congure it to have static parts of the name that are kept
on a Module recall and not replaced with the name of the recalled module. With the Dynamic Module Label
feature it is possible to specify a Sufx, or a Prex and Sufx for the module label. To enable this feature,
the pipe character is used (|) in the Module Label.
Example with both Prex and Sufx (two pipe characters used in the label):
Module label displayed on work area before recall: Right 80deg Rack1:1
Starting module label: Right |80deg| Rack1:1
Name of Module le being recalled: 120deg
Module label after recall: Right |120deg| Rack1:1
Module label displayed on work area after recall: Right 120deg Rack1:1
Table 8-4: Table 8-4: Example with both Prex and Sufx (two pipe characters used in label)
Example with only Sufx (one pipe characters used in the label):
Module label displayed on work area before recall: 80deg Rack1:1
Starting module label: 80deg| Rack1:1
Name of Module le being recalled: 120deg
Module label after recall: 120deg| Rack1:1
Module label displayed on work area after recall: 120deg Rack1:1