Quick Start Guide

11. Product overview

D SERIES Lake Quick Start Guide rev 3.0.3

11.2. Additional front panel operations and indications

11.2.1. Frame reset

A factory reset and soft reset can be performed from the front panel. A factory reset will restore all settings to

original defaults, including network settings, frame presets and current settings. A soft reset reverts only the current

settings to default. Network settings and frame presets are not changed with a soft reset.

1. Place the frame in standby mode.

2. Press and hold Select and channel 3 mute button. Then press the power button.

3. User interface will illuminate available options. Choose from the options below

a. Press channel 1 mute button (red LED) to initiate the factory reset sequence.

b. Press channel 2 mute button (amber LED) to initiate the soft reset sequence.

c. To cancel, press channel 4 mute button (green LED).

4. Wait state indication is present while either reset is performed.

5. To complete the factory reset process, cycle the mains power by completely removing the power plug and

reinserting it.

11.2.2 Wait indication

Wait indication is displayed when the frame is performing an operation. All LEDs except power are unlit and a

circling amber light is displayed on channels 1 and 2.

11.2.3 Power cycle required indication

After an operation that requires a subsequent power cycle to complete, the power LED blinks alternately red and

green. A power cycle requires that the mains are completely removed from the device and not connected again

until the device has powered off.

11.2.4. Front panel lock

The front panel can be disabled from the Lake Controller. When the front panel is disabled, LEDs 4, 8 and 9 (all

buttons on the lowest row) ﬂ ash in amber when hitting any touch button.

11.3. Rear panel

Ampliﬁ er Outputs - The ampliﬁ er output connectors are sturdy terminal block connectors. See Technical

Speciﬁ cations (Section 15) for connector rating. Channels are located from left to right. Each channel has a clearly

marked hot (+) and cold (-) terminal

Analog Inputs - Analog inputs are available on terminal block connectors with clearly marked hot (+), cold (-)

and ground terminals

AES3 Inputs - AES3 inputs are available on terminal block connectors with clearly marked hot (+), cold (-)

and ground terminals

RJ-45 Ethernet connectors for control and Dante digital audio network

Mains connector - Detachable Neutrik powerCON (for D 200, D 120 and D 80) or locking IEC connector

(for D 40, D 20 and D 10). See Technical Speciﬁ cations (Section 15) for connector rating

1 2

3 4