Lake Controller Operation Manual Version 1.7.0

74
Lake Controller Operation Manual Rev 1.7.0
EQ/Levels Menu Reference
Label Function Description
A Module Output
Selector
Select the Module Output to work on. For an XP1way, there is only one module
output. XP2way will display two ouputs, XP3 will display three outputs and XP4
will display four outputs.
Below the selector, the Label(s) of each band within that output are displayed.
If the band is muted, the label is displayed in red. If the band is bypassed, the
label is displayed in grey. The number of bands displayed depends on how many
bands the output has. If the Multiband Limiter is disabled for an Output, it will
say “DISABLED” in black on grey background.
B Split Frequency
Control
Displays and enables adjustment of the split frequency used for the proprietory
Zero Phase Shift crossover lters creating the bands.
C Enable the Multi-
band Limiter
This button enables or disables the Multiband Limiter for the selected Module
Output. This makes it possible to enable the Multiband Limiter on one or more
of the Module outputs for the Module individually.
D Select Fader
Function
Selects what function the Fader will have:
MaxRMS Level
MaxRMS Corner
MaxRMS Attack
MaxRMS Release
MaxPeal Level
E Desiger Mode
Selections
These buttons are only available while in Designer mode for an unlocked module.
Level Limits = will display the Level Limits conguration for the Multiband Limiter
as well as other access rights.
Adjust Factory = makes it possible to congure Factory offset values.
F ALL The ALL view will display Meters and Mute buttons for all bands within the
Module. For example, for a XP4way with all three bands enabled on each mod-
ule output, ALL view will display all 12 bands at the same time.
G Band Button Each band within the Multiband Limiter have a button below the meter. By
default, this is a mute button, but the function for the button is selected in the
Buttom Mode menu (I). The button can function for:
Mute = Mute or unmute the selected band
Bypass = Bypass all limiters for the band
Label = Label the band
Merge/Split = Merge the center band with either the lower and/or the higher
band, making it possible to create a two-band or one-band multiband limiter.
H Module Output
Button
Button for the Module Output selected in (A) and function selected in (I).
I Select Button
Function
This selection will decide the function of the band buttons (G) and Module
output button (H)
J Band Fader The band fader will adjust the limiter threshold for the function selected in (D).
Drag the fader up or down to adjust its level. Drag below, above, or to the left of
the fader to adjust by smaller increments.