Lake Controller Operation Manual Version 1.7.0

304
Lake Controller Operation Manual Rev 1.7.0
External Control Interfaces
▸ Preset Store (not applicable for MY8-LAKE)
▸ Adjustment of amplier gain and Voltage Peak Limiter (Lake-enabled Ampliers only)
▸ Activation of LoadPilot on individual power output channels (PLM+ and D Series only)
▸ Activation of data transmission for amplier output voltage and current via Dante (Lake-enabled Ampli-
ers only
Additionally, the following parameters may be retrieved from all devices (except MY8-LAKE) using the DLM
Protocol:
▸ Preset Name, Firmware Version, Unique ID and Mac Address
▸ IP Address and Subnet Mask
▸ Dante Break-In and Enable Status
▸ Input Activity and Conguration
▸ Metering and Fault Information
▸ Current DSP > Amp Routing (Lake-enabled Ampliers only)
▸ Output channel Impedance Measurement in Ohms (PLM+ and D Series only)
These external control systems must form valid Ethernet packets that follow the requirements of the
network packet specication. Please email [e-mail] to obtain the information required
for integration.
25.3 Q-SYS Plugin
For PLM+ and D Series, there is a native Q-SYS Plugin that can be downloaded from labgruppen.com which
integrates natively in the Q-SYS environment.