Lake Controller Operation Manual Version 1.7.0
Lake Controller Operation Manual Rev 1.7.0
Groups Menu Reference
189
10.3.4 Keep Group Assignment on Module Recall
If the Keep Group Assignment function is disabled (default) on the Modules Store/Recall menu, Group assign-
ments will be lost when a Module is recalled. A warning message will be displayed to conrm this action.
If the Keep Group Assignment function is enabled on the Modules Store/Recall menu, Group assignments
will be maintained when a Module is recalled.
Modules will not allow assignment of Group/s if it
will result in level limits being exceeded. Warning
messages will be displayed if a Group assignment
would cause the Module to exceed its level limits.
The rst Module assigned to the Group will be
used for Group level metering purposes. This
metering assignment can be changed later if
required; please refer to section 6.2.7.
10.4 Label
The Group label is a user-dened value at the bottom of the Group icon that is useful for identifying the part
of the sound system to which the Group communicates (front of house, monitors, down-ll, and so on).
To label a Group, perform the following steps:
1. Tap the desired Group icon.
2. Tap LABEL and enter a Group label.
3. Tap OK.
10.5 Copy/Paste
Select a Group in the work area, and tap COPY/PASTE to view a submenu that transfers attributes between
Groups.
10.5.1 Copy
The COPY button is active only when a Group icon is selected. To copy data from a Group, tap the Group
icon that contains the data to be copied, then tap COPY.
10.5.2 Paste
The PASTE button is active only when Group data has been previously copied and a Group icon is selected.
To paste data to a Group, tap the Group icon in which to paste the copied data then tap PASTE.
The Paste operation overwrites all the destination
Group’s EQ and Levels settings, but not the Module
label or Module assignments.