Manualshelf

Lake Controller Operation Manual Version 1.7.0

ManualsBrandsLab Gruppen ManualsPower Amplifiers1000W Amplifier with 4 Flexible Output-Channels, Lake Digital Signal Processing and Digital Audio Networking for Installation Applications
161162163164165166167168169170
Lake Controller Operation Manual Rev 1.7.0
Modules Menu Reference
159
8.4.3 Replace Frame
The REPLACE function allows transfer of Module/Super Module/Group data between devices. If a previ-
ously used device is unavailable, or the device that performs a task is required to change, follow these
steps:
1. Tap COPY/PASTE/REPLACE from the Modules menu.
2. Tap a Module from the Frame you wish to replace on the work area.
3. Tap REPLACE FRAME
The Module scroll bar displays used and unused Modules.
4. Tap a Module from an unused Frame then tap COMPLETE REPLACE.
To locate a particular device, tap the SEL button on the front panel to center the unit on the scroll bar:
▸ LM Series | Press the top-left dynamic function button on the front panel
▸ PLM Series | Press the second dynamic function button down on the left on the front panel
▸ PLM+ Series | Press the top-left dynamic function button on the front panel
▸ D Series | Press the SELECT button to the far-right of the front panel
8.4. 3.1 Replace Frame Rules and Compatibility
▸ All Modules of a Frame must be present on the Module scroll bar (i.e. no part of the Frame can be in
use in the current system conguration)
▸ Network IP settings and Dual Redundancy conguration are not transferred during a Frame Replace
operation; congure this manually on the destination Frame.
▸ PLM 10000Q and PLM 20000Q Frames may be replaced with PLM+ or D Series, and will populate
Modules A&B only. Modules C&D will remain unaffected.
▸ PLM+ or D Series may be replaced with any product from either of these product lines without any
loss of data. If a destination model cannot set a value contained in the source model, the appropriate
minimum or maximum will be set and these discrepancies are indicated via the desired values and
actual values within brackets [ ]. These products may not be replaced by a legacy PLM product.
▸ PLM 14000 can only be replaced with an online PLM 14000.
▸ For LM Series and MY8-LAKE devices, the source and destination Frames must be of the same
conguration type (i.e. Contour, Mesa, or Contour/Mesa), and can only be replaced with a Frame of the
same product type.