Lake Controller Operation Manual Version 1.7.0

154
Lake Controller Operation Manual Rev 1.7.0
Modules Menu Reference
If the FIXED IP ADDRESS option is selected as described in 8.2.10.5, this eld becomes editable and an
Subnet Mask may be entered manually.
This parameter is unaffected by SYSTEM RECALL, FRAME PRESET RECALL or soft FRAME RESET
options. It is reset only via the FACTORY RESET option from the front panel of the device.
8.2.10.8 ID
The unique Lake device identier.
8.2.10.9 Firmware
The rmware version that is currently running on the selected device.
8.2.10.10 Serial Number
Device as well as the front and rear panel display (not applicable for D Series and MY8-LAKE).
Displays the hardware serial number for the selected device. This is visible on the rear panel and in the front
panel menu (not applicable for D Series and MY8-LAKE).
8. 2 .11 Input Router Mutes
Input Router Mutes represent the actual inputs to the device. Muting an input via Input Router Mutes will
mute the signal to all Modules that are connected to that Input Router. To display the Input Router Mutes
tool-bar:
▸ Tap INPUT ROUTER MUTES (F6) from the button bar on the I/O CONFIG screen
▸ Tap the INPUT ROUTER MUTES zoom button from the Levels screen
The buttons describe the current status. An input with a red button labelled MUTED is currently muted and
may be tapped to unmute the input. A button labelled UNMUTED is currently unmuted and may be tapped
to mute the input.
Figure 8-28: Input Router Mutes