Lake Controller Operation Manual Version 1.7.0

108
Lake Controller Operation Manual Rev 1.7.0
EQ/Levels Menu Reference
6.5.2 Using Auxiliary Outputs
To congure a Module for output-specic EQ, rst load an Auxiliary Output le into a Module.
1. From Home, tap MODULES.
2. Place Module A of a Frame on the MAIN page, or select an existing Module.
3. Tap MODULE STORE/RECALL.
4. Select an Auxiliary Output le from the scroll bar, and tap RECALL.
5. Read and tap YES to both warning messages.
Figure 6-22: Loading an Auxiliary Output le
6. After loading an Auxiliary Output Module le, access EQ/LEVELS for this Module by tapping
STORE/RECALL EXIT, then tap EQ/LEVELS
6.5.3 Adding Output-Specic EQ
The available overlays for the 3-Auxiliary Outputs Module are shown in Figure 6-23.
:
Figure 6-23: Auxiliary Output Tabs for 3-Aux Module
The Levels, PEQ & BLEQ screens are the same for all Module types. Refer to section 6.1 for further infor-
mation.
The XOVER tab is not displayed as it is not relevant for this Module type. The XOVER tab will be present for
the Classic 2-Way + 1-Auxiliary Outputs (CL2w+1a) Module.
Three additional AUX tabs are present, providing individual high-pass, low-pass, and EQ lters for
each output.