Operation Manual
4. Product Overview
C SERIES Operation Manual rev 2.0.0
11
4. Product Overview
4.1. Front Panel Overview
ON/OFF
C10:8X
REMOTE
C SERIES
LABEL AREA
TEMP
VHF
CPL
VPL | CLIP
SIG | HI-IMP
TEMP
VHF
CPL
VPL | CLIP
SIG | HI-IMP
CH|A CH|B CH|C CH|D CH|E CH|F CH|G CH|H
MUTE
FAU LT
MUTE
FAU LT
MUTE
FAU LT
MUTE
FAU LT
POWER
BRIDGE BRIDGE BRIDGE BRIDGE
PAL
The amplier’s front panel presents the performance and fault condition indicators, power and remote switches,
and a removable dust-lter cover. Four level potentiometers located behind the cover provide individual attenuation
for the four amplier channels. Range is 0 dB to - innity. The 12 o’clock position indicates -10 dB attenuation.
A label area is located beneath the LED display.
To remove the dust-lter cover, loosen the thumbscrew at the far left. This allows removal of the dust-lters
for cleaning, and provides access to channel attenuation. The front cover may be made “tamper resistant” by
replacing the thumbscrew with a Philips head or safety Torx screw. Thread size is M3.
NOTE: Never operate the amplier without the dust-lters in place.
4.1.1. Power on/off and remote switch
The Power on/off switch is located on the right side. A second switch, labeled “REMOTE,” is located above
the Power switch. When the Remote switch is on, (with the mains connected and power switch turned on) the
yellow LED above it will illuminate indicating that external power on/off commands from the NomadLink network
connection will switch the amplier on or off. When Remote is activated the amplier will not switch on until a
“Power On” command is received from the network. When the remote switch is off, it is not possible to switch
amplier power on or off using NomadLink network control.