Operation Manual

4. Product Overview
12
C SERIES Operation Manual rev 3.0.0
4.2. Rear panel
4.2.1. The DIP-switch features
The following features may be adjusted using the DIP-switches on the rear-panel of the amplier.
Gain - Set for all four or eight channels from +29 to +38 dB in 3 dB steps.
Fan Masked - When on, engages the intelligent fan feature; fan speed is lowered when no signal is present.
Bridge Mode - Switches the channel pairs into bridge mode operation. An automatic -6 dB gain compensation is
applied.
VPL - Voltage Peak Limiter adjustment is provided for 8 individual levels. Select the setting most appropriate for
connected speakers. See Appendix for details.
Mode - Select VPL mode between Hard and Soft. For channels driving sub-woofers and low-end frequencies, it
is recommended to use the Hard setting for optimal operation. For mid- and high-frequency drivers, always select
Soft.
Mains input 115 V
and 230 V operation
(Not selectable)
NomadLink network
In and Out on
EtherCon-housed
RJ45 connections
DIP-switches for
adjusting key features
(see below)
2-pole screw
terminal output
connections
3-pole Phoenix
input connectors
WIRING
NORMAL: CLASS 2
BRIDGED: CLASS 3
44dB
41dB
38dB
35dB
32dB
29dB
26dB
23dB
141V*
118V
100V**
85V
71V
59V
50V
42V
*100V
rms
**70V
rms
Ser. N:o
Removed!
SPEAKER OUTPUTS
BALANCED INPUTS
CH D
CH BCH C CH A
Made in Sweden
200-240V 50-60Hz :2500W
C 88:4
Must be grounded/earthed