Install Instructions

ManualsBrandsLaars ManualsBoilersNTH-210 194,000 BTU Neotherm Residential High Efficiency, Floor Mount Heat Only Condensing Boiler (NG)

Page 75

NEOTHERM Residential Boilers

HIGH EFFICIENCY RESIDENTIAL BOILERS

®

205 Invalid Outlet high limit response setting L

1. Recheck selected parameters, reverify and reset module.

2. If fault repeats, verify electrical grounding.

3. If fault repeats, replace module.

207 Invalid PII (Pre-Ignition Interlock) enable

setting

L

210 Invalid Postpurge time setting L

211 Invalid Power up with lockout setting L

212 Invalid Preignition time setting L

213 Invalid Prepurge rate setting L

214 Invalid Prepurge time setting L

215 Invalid Purge rate proving setting L

216 Invalid Run ame failure response setting L

217 Invalid Run stabilization time setting L

218 Invalid Stack limit enable setting L

219 Invalid Stack limit response setting L

220 Uncongured Delta T limit setpoint setting L

221 Uncongured DHW (Domestic Hot Water)

high limit setpoint setting

L

222 Uncongured Outlet high limit setpoint

setting

L

223 Uncongured Stack limit setpoint setting L

224 Invalid DHW (Domestic Hot Water)

demand source setting

L

225 Invalid Flame threshold setting L

226 Invalid Outlet high limit setpoint setting L

227 Invalid DHW (Domestic Hot Water) high

limit setpoint setting

L

228 Invalid Stack limit setpoint setting L

229 Invalid Modulation output setting L

230 Invalid CH (Central Heat) demand source

setting

L

231 Invalid Delta T limit delay setting L

232 Invalid Pressure sensor type setting L

234 Invalid Outlet high limit enable setting L

235 Invalid Outlet connector type setting L

236 Invalid Inlet connector type setting L

237 Invalid DHW (Domestic Hot Water)

connector type setting

L

238 Invalid Stack connector type setting L

239 Invalid Header connector type setting L

240 Invalid Outdoor connector type setting L