Install Instructions
Page 74
LAARS Heating Systems
184 Invalid Blower/ HSI output setting L
1. Recheck selected parameters, reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
185 Invalid Delta T limit enable setting L
186 Invalid Delta T limit response setting L
187 Invalid DHW (Domestic Hot Water) high
limit enable setting
L
188 Invalid DHW (Domestic Hot Water) high
limit response setting
L
189 Invalid ame sensor type setting L
192 Invalid igniter on during setting L
193 Invalid ignite failure delay setting L
194 Invalid ignite failure response setting L
195 Invalid ignite failure retries setting L
196 Invalid ignition source setting L
197 Invalid interlock open response setting L
198 Invalid interlock start check setting L
199 Invalid LCI (Limit Control Input) enable
setting
L
200 Invalid lighto rate setting L
201 Invalid lighto rate proving setting L
202 Invalid MFEP (Main Flame Establishing
Period) time setting
L
203 Invalid MFEP (Main Flame Establishing
Period) ame failure response setting
L
204 Invalid NTC sensor type setting L










